Category: News

 The air compressor can only be started when the indoor temperature of the air compressor room is kept above 5°C.   Close the sliding door of the exhaust air outlet of the air compressor unit that is not open, and close the indoor hot air exhaust outlet to ensure…

Effects of air compressor vibration:   Cause failures such as cylinder pulling and tile burning.   Increase equipment power consumption and waste energy.   Make noise and affect the surrounding environment and workers.   Cause instrument failure and affect the stability of normal operation.   The wear of the frictional…

  Low noise: The output air pressure is stable without fluctuation, minimizing noise pollution. It is suitable for analysis and testing, laboratory support, laboratories of various universities, research institutes, environmental protection, health and epidemic prevention and other testing departments.   Oil-free and water-free: The oil-free air compressor solves the problem…

There are several ways to reduce motor losses:   Stator loss. Increase the full slot rate of the stator slot, which is better for low-voltage small motors. The full slot rate of the stator can be increased by applying winding and insulation dimensions, and a large cross-sectional area of the…

Good ventilation conditions: This is beneficial to ensure that the ambient temperature is within a suitable range, so as to ensure that the exhaust temperature will not be too high.   Good air quality: In theory, the air quality is directly related to the service life of the oil-free screw…

After the machine is cleaned and installed, the operating parameters of the air compressor should be adjusted to ensure the normal and safe operation of the social insurance:   Preparations before starting the screw air compressor: (1) Belt (coupling) correction: If the air compressor is driven by a belt, the…

The following points may cause part of the flue gas of the screw air compressor:   Oil separator failure: replace the oil separator.   Low exhaust pressure: increase the exhaust pressure (adjust the setting value of the pressure switch).   The oil level is too high: check the oil level…

Mainly should start from the following aspects:   Check whether the oil content of the condensed water discharged from the trap is large. If so, check the leakage point in the unit and eliminate it.   Check whether the opening pressure of the minimum pressure valve is normal. If so,…

  The gas storage tank and air compressor are placed in a well-ventilated working place, and a humid environment is prohibited. There must be no welding operations within 20 meters around, and pay attention to regular cleaning.   Keep 0 load when starting, otherwise it may cause failure and shutdown…

   What factors should be considered in blower selection?   Air volume. Air volume, also known as flow, is the volume of air delivered by the fan per minute. The unit is usually cubic meter/min or cubic meter/h. Air volume is an important basis for fan selection. The fan…